$95.21
Part # 9995541-R1
Maytronics® Active Brush Assembly – 9995541-R1
Genuine Maytronics® replacement active brush assembly for select Dolphin® robotic pool cleaners. Designed to provide maximum scrubbing action for enhanced cleaning of pool floors, walls, and waterlines.
Why this part?
✅ Restores cleaning performance by replacing worn or damaged brushes
✅ Active scrubbing helps loosen dirt, algae, and debris for easier vacuuming
✅ Exact OEM fit — designed specifically for listed Dolphin® models
✅ Durable build — engineered to withstand pool chemicals and UV exposure
Compatibility
✅ Fits the following Maytronics® / Dolphin® models:
Supreme M500
Supreme M400
Supreme M5
Liberty
C3
C4
Wave 90
➜ OEM Part Number: 9995541-R1
⚠️ Not compatible with all Dolphin® cleaners — confirm model before ordering.
What’s included
(1) ✅ Active brush assembly – 9995541-R1
Install notes
➜ Turn off and unplug cleaner before service
➜ Remove old brush assembly and install new brush in the same orientation
➜ Check tracks and rollers for wear while replacing brush
⚠️ Installing an incorrect brush can cause cleaning inefficiency or damage to the cleaner.
Disclaimer
⚠️ Compatibility is based on manufacturer data. Always verify your cleaner model and existing brush type before purchase, as similar Dolphin® models may use different brush assemblies depending on production year.
Can you buy just the bearings for this assembly. It is about an inch and a quarter plastic bearing that goes in the end assembly of this brush. If not the bearings can you buy just the gear and end assembly. I don’t need the whole brush. We just have one bearing that is bad.
Reply
Hi, Thomas. Unfortunately, replacement parts are not available for this Active Brush Assembly - 9995541-R1.
Reply
will part # 9995541-r1 fit a dolphin supreme m4?
Reply
Hi Walter, the correct active brush assembly for the Maytronics Dolphin Supreme M4 robotic pool cleaner is part number 9995540-ASSY.
Reply
Less than 1 hr
Screwdriver
Unplug the dolphin, remove the four screws from the old assembly. The new assembly fits perfectly in the space from the old, insert new screws that are included. I plugged the dolphin back in and returned to the pool, so easy.
1 to 2 hrs
Screwdriver
2 0
- I gave the Dolphin a thorough cleaning to remove all debris from the cleaner.
- I removed the bottom brush to see why the Dolphin wasn't moving even though there was clearly power to the unit.
- I got lucky and saw a ball bearing fall from the Dolphin. After closer inspection I could see ball bearings on one side of the brush but not on the other side.
- I knew this would impact the unit's ability to move and decided to order the replacement brush assembly at about 10% of the cost for a new unit. We were fortunate... It worked!!
-