Product Description

INYO # 3816-313 AQUASTAR # WAV12103 THIS IS COMPLIANT WITH THE ASME/ANSI A112.19.8-2007 REGULATIONS AS SPECIFIED BY THE VIRGINIA GRAEME BAKER POOL AND SPA SAFETY ACT THIS IS A VGB-2008 COMPLIANT FRAME AND COVER

************************************************

GENERAL DESCRIPTION: 12" X 12" SQUARE FRAME AND COVER, LIGHT GRAY

************************************************

BASIC SPECS: SCREW HOLES: 1 IN THE CENTER OF EACH SIDE USAGE: APPROVED FOR FLOOR OR WALL USAGE SPECS: SPECS SHOWN ARE FOR A SINGLE UNIT FLOOR: 361 GPM @ 1.3 FPS WALL: 361 GPM @ 1.3 FPS LIFE: 5 YEARS TOTAL OPENING: 85.2 SQ INCH 400 GPM @ 1.5 FPS

************************************************

THIS IS A 12" X 12" SQUARE COVER AND FRAME WITH SCREWS THIS HAS A REGULAR GRATED SHAPE BUT THE COVER SLOPES SLIGHTLY UPWARD FROM THE OUTSIDE TOWARD THE CENTER. THERE ARE A LARGE NUMBER OF SEMI-CIRCULAR EXTENSIONS RUNNING IN ONE DIRECTION ON TOP OF EACH GRATE. THIS HAS A ROUND CENTERPIECE WHICH CONTAINS THE VARIOUS LABELS REQUIRED BY THE VGB LAW EACH SIDE OF THE COVER HAS A SQUARE NOTCH AT THE BOTTOM IN THE CENTER OF EACH SIDE. THE FRAME HAS MATCHING SQUARE TABS WHICH CONTAIN THE SCREW HOLES. MATERIAL: PLASTIC COVER AND FRAME, STAINLESS STEEL SCREWS COLOR: LIGHT GRAY SHAPE: SQUARE

************************************************

FRAME & COVER DIMENSIONS: TOTAL HEIGHT: 1-31/32" (B) FRAME ONLY HEIGHT: 29/32" FRAME LENGTH & WIDTH AT PLASTER LINE: 12-5/16" (A) FRAME MAXIMUM LENGTH & WIDTH AT BOTTOM: 13-7/32"

************************************************

COVER DIMENSIONS: COVER OUTSIDE LENGTH & WIDTH: 11-7/8" COVER ONLY HEIGHT: 1-13/16" COVER EXTENDS 1-1/8" MAXIMUM ABOVE THE FRAME WHEN INSTALLED THE COVER IS 3/4" TALL AT THE EDGE. SPECIAL NOTE: THE WAV 12 X 12" COVER IS USED IN THIS FRAME AND COVER. THE RWAV 12 X 12 RETROFIT COVER IS TALLER AND HAS EXTRA HOLES. THE RWAV IS SOLD AS A REPLACEMENT COVER ONLY.

************************************************

SCREW HOLES: TOTAL SCREW HOLES: 4 THERE IS A SCREW HOLE IN THE CENTER OF EACH SIDE THE CENTER OF THE SCREW HOLE IS 5/16" FROM THE EDGE FROM THE CENTERLINE OF EACH SCREW HOLE TO THE CENTERLINE OF THE SCREW HOLE ON THE OPPOSITE SIDE IS 11-1/4". THERE IS A 3/8" TALL X 5/8" LONG NOTCH JUST BELOW THE SCREW HOLE IN EACH SIDE. THIS NOTCH MATCHES THE CORRESPONDING TAB ON THE FRAME

************************************************

SCREWS: 4 SCREWS - #10 X 3/4" LONG SS, SELF TAPPING PHILLIPS HEAD THESE ATTACH THE COVER TO THE FRAME

************************************************

MARKINGS: WAV12-XXX IS MOLDED INTO THE TOP OF THE COVER IN THE CIRCULAR CENTER PIECE THE FRAME HAS NO MARKINGS THE SPECS REQUIRED BY THE VGB-2008 LAW ARE MOLDED ON THE COVER