$111.94
Part # 5030-07B
Manufacturer Code 310-5130
Dimensions 3.85" X 0.885"
INYO # 5030-07B WATERWAY # 310-5130 THIS IS A 1 HP IMPELLER USED ON THE CENTER DISCHARGE AND ON BATH PUMPS
************************************************
GENERAL DESCRIPTION: CLOSED FACE GRAY IMPELLER, 1 HP THE SHAFT SIDE OF THE IMPELLER HAS A RIDGE WHICH EXTENDS ABOUT 1/4" PAST THE FACE. THIS ALSO HAS A RING AROUND THE SHAFT COVER ABOUT 1-5/8" DIAMETER AND 3/8" TALL THE INLET SIDE OF THE IMPELLER HAS A RIDGE WHICH EXTENDS ABOUT 3/16" PAST THE FACE.
************************************************
MATERIAL: GRAY PLASTIC TYPE: CLOSED FACE NUMBER OF VANES: 5
************************************************
DIMENSIONS: OUTSIDE DIAMETER 3-7/8" TOTAL LENGTH: 2-1/2" OUTSIDE THICKNESS AT EDGE: 13/16" INSIDE THICKNESS AT EDGE: 5/16" SHAFT LENGTH: 1-1/2" SHAFT DIAMETER: 5/8" INLET OPENING OUTSIDE DIAMETER: 1-11/16" INLET OPENING INSIDE DIAMETER: 1-3/8"
************************************************
MARKINGS: MOLDED ON THE INLET SIDE ONLY CENTER DISCHARGE COVER 313-1130 1 HP ASSY 310-5130
does impeller #310-5130 come with the screw, and, if so, is the screw still a plastic material? Is there a tool to help remove the impeller, or is it just a matter of removing the screw? Could I get additional screws?
Reply
Hello Conrad, The impeller does come with the plastic retaining screw. There is no part number I could find strictly for the screw. You will need to remove the screw before attempting to remove the impeller. You can use a Strap Wrench, found at any local hardware store, to help in the removal of the impeller.
Reply
can impeller # 310-5130 be used with a o smith 1 hp pump motor part # ust 1102
Reply
The correct impeller size is determined by the Pump make and model, as well as the horsepower of the motor. If you can provide additional information on the pump, I will be better able to assist you.
Reply
I plan to buy an A. O. Smith 1hp round flange up rate motor that you sell. Your part # is UST 1102.
is the Impeller 310-5130 part # 53030-07B the right one for this motor?
Reply
Steve, The impeller will depend on the make and model of the pump not the motor. What is your pump model?
Reply
The Most Recent Reviews
(5 out of 5 stars) Great impeller
Reviewed By: Mark F. from Colorado ()
Simple to replace just don't forget to get the new seal
Was this review helpful to you?