Part # 4041-08A
Manufacturer Code G-115
Dimensions 8-1/8" x 8"
INYO # 4041-08A HAYWARD # SPX1090E GENERAL DESCRIPTION: THIS IS A HAYWARD PRODUCTS STANDARD SMALL SKIMMER FACEPLATE GASKET MATERIAL: CARDBOARD SHAPE: RECTANGULAR WITH A TOTAL OF 10 SCREW HOLES AND 2 EXTRA HOLES THERE ARE 3 SCREW HOLES ON THE TOP AND THE BOTTOM THERE ARE 2 SCREW HOLES AND ONE EXTRA HOLE ON EACH SIDE.
*******************************************************************************
DIMENSIONS: OUTSIDE LENGTH: 8-1/8" (A) OUTSIDE HEIGHT: 8" (B) INSIDE LENGTH: 5-7/8" INSIDE HEIGHT: 5-3/4"
*******************************************************************************
SCREW HOLES: THESE ARE 1/4" IN DIAMETER EXTRA HOLES: THESE ARE 1/2" IN DIAMETER TOP AND BOTTOM: THERE IS A SCREW HOLE IN THE CENTER THE 2 SCREW HOLES NEXT TO THE CENTER HOLE ARE 2-3/8" FROM THE CENTER HOLE SIDE: THERE IS AN EXTRA HOLE IN THE CENTER THERE IS A SCREW HOLE ABOVE AND ONE BELOW THE CENTER HOLE THE 1/4" SCREW HOLES ARE 1-7/8" APART AT THE CENTER
*******************************************************************************
MARKINGS: THERE ARE NO MARKINGS
*******************************************************************************
SUBSTITUTES: THE 4042-06 CARDBOARD GASKET WILL REPLACE THIS, BUT IS SMALLER ON THE OUTSIDE THE 9381-04 CARDBOARD GASKET WILL REPLACE THIS, BUT IS SMALLER ON THE OUTSIDE THERE SHOULD BE OTHERS, JUST CHECK THE HOLE PATTERN NOTE DATE: 5-4-2009
MY SKIMMER HAS A GASKET ON BOTH SIDES OF THE WALL. DO I NEED TWO GASKETS?
Reply
The two gaskets will help make a tight seal, it is not required but I highly recommend that two gaskets are used.
Reply
