Part # 342061010
Warranty 1 Year
Dimensions 15.5" L x 8.5" W x 6.5" D
Waterway® Hi-Flo II Spa Pump – 1.5 HP, 2-Speed, 115V (342061010)
✅ High-Flow Side Discharge Design for Faster Filtration
⚠️ Verify Voltage and Frame Size Before Ordering
❌ Not for Inground Pool Use
Key Features
✅ 1.5 HP, 2-Speed Motor – efficient low & high speed operation
✅ 48-Frame motor, side discharge for maximum flow efficiency
✅ 2" Intake and 2" Discharge connections
✅ Up to 60% more efficient than center discharge pumps
✅ Large 6.5" diameter wet end delivers higher head pressure
✅ Wet end rotates for flexible installation
✅ Compact design: 7.5" H x 7.375" W x 14.23" L
System Compatibility
✅ Designed for portable spas and hot tubs requiring side discharge
✅ Compatible with most spa plumbing using 2" unions
⚠️ Confirm plumbing size and voltage (115V) before ordering
❌ Not suitable for standard inground pool filtration systems
Recommended Accessories
⚠️ Union Fittings & Gaskets (2") – replace when installing for a leak-free fit
⚠️ Replacement Shaft Seal Kit – install with new pump or when rebuilding motor
❌ Reusing old seals and unions risks leaks and premature motor failure
What’s Included
✅ Complete Waterway® Hi-Flo II Pump (1.5 HP, 2-Speed, 115V, 48-Frame Motor with Wet End)
Tech Tips
✅ Check Wiring: Ensure pump is wired correctly for 115V operation.
⚠️ Allow Ventilation: Install in a dry, well-ventilated location to prevent overheating.
✅ Rotate Wet End if Needed: Adjust orientation for easiest plumbing connection.
❌ Do Not Run Dry: Operating without water will destroy seals and shorten pump life.
I need to know if this pump has an external capacitor located on top of the pump. The unit I want to replace has clearance issues and an external capacitor located on the top of the pump will not fit. Your information on your website does not specify. Please advise.
Reply
Patrick, The photo that was provided from the MFGR and from the warehouse is the same photo that we have on the website that does not show an external capacitor.
Reply
Is this pump ok to use with a Cartridge filter system
Reply
Yes this pump is okay to use with a cartridge filter system. Normally this pump is used on portable spas or hot tubs. If you are using on an above ground pool then we would suggest the version of this pump which has basket, here you can view this Waterway Pump With Basket.
Reply
I need a manuel and or warranty info for model # ps-20-2n11md. Can you help me find one I can print out please?
Reply
Good day. I was able to find a MANUAL on the WATERWAY WEBSITE. For warranty issues, I could not a spot on the site. I did find a Tech Support line - 888-72-5387. I am sure they would be able to get you what you need.
Reply
-XL.jpeg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&mode=pad&width=650&height=650 "Waterway® Hi-Flo II Spa Pump - 1.5 HP, 2-Speed, 115V (342061010)")
-XL.jpeg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&height=45&width=45&mode=pad "Waterway® Hi-Flo II Spa Pump - 1.5 HP, 2-Speed, 115V (342061010)")
The Most Helpful Review
2 1
(5 out of 5 stars) Quiet pump!
Reviewed By: Buddy from Philly metro ()
This is a side discharge unit but ships as shown (with discharge facing upwards). You can change the position of that discharge by rotating it however you need. There are four long hex head set screws (which run the length of the motor into the pump) accessible from the rear of the motor, which need to be loosened. Once you remove them, just rotate as appropriate and retighten...done!
Was this review helpful to you?
The Most Recent Reviews
2 0
(5 out of 5 stars) Great
Reviewed By: Inyo Customer ()
Great
Was this review helpful to you?