1. Home
  2. How To Guides
  3. How to Replace an Aqua Rite Display PCB

How to Replace an Aqua Rite Display PCB

WRITTEN BY: 

  3.75 out of 5 stars on 4 ratings
(Click on a star to add your rating)

The Display Board (GLX-PCB-DSP) for the Hayward Aqua Rite will occasionally fail. Most of the time this is due to an electrical surge. The following steps will provide a guide on how to replace the GLX-PCB-DSP.



Comments

Email

Print

Steps

Things You'll Need

AquaRite Display Board O.E.M

AquaRite Display Board After Market

Video

Step by Step

Top

Step 1

TURN OFF THE POWER TO THE TIMER BOX. There should be a circuit breaker before the timer box where the power can be turned off.

Step 2

Unlatch the lock and open the door to the Hayward Aqua Rite control box.

Step 3

Using a 5/16" socket, remove the 2 screws that secure the cover panel to the box.

Step 4

Pull the cover panel out of the Aqua Rite control box.

Step 5

Pull the Display PCB off of the Main PCB. The GLX-PCB-DSP will simply lift right off of the Main PCB.

Step 6

Install the new Display PCB (GLX-PCB-DSP). Make sure the long pins from the Main PCB match up with the holes on the Display PCB.

Step 7

Place the control box panel into the control box.

Step 8

Tighten the two cover screws with a 5/16" socket.

Step 9

Turn on the power at the circuit breaker.

Step 10

The "Power" light and the display should be illuminated if everything is operating correctly.

Step 11

Close the door to the Hayward Aqua Rite and continue to enjoy the beneifits of your salt water pool.

Comments

Top
Add a Comment
(1 to 1 of 1)

Anonymous  Posted: 4/8/2014 

This was so easy to install. Took about 5 minutes (that's including taking out and putting the screws back in)! Video shows exactly how it is done.
 Reply