Jun 25, 2018 ... Now the motor runs until it heats up and the thermal protection turns it off. I disassembled the motor from the pump to see if anything was ...
Apr 5, 2018 ... I' m trying to find the motor bearings , I found the kit for seal, but I need the bearings for the motor, it is whining real loud, ...
Sep 18, 2018 ... There could be a couple issues. Your original 2hp motor may have been full rated and your new 2hp motor is uprated. If that's the case, your ...
If your pool pump motor starts but shuts down unexpectedly it is probably overloaded and the thermal overload protection device has tripped. This guide discusses what to look for to correct this issue...
If your pool pump motor is smoking of cycling on and off, it is severely overheating. This guide discusses some of the conditions that cause your <a href="https://www.inyopools.com/ProductList...
Jul 16, 2015 ... If your motor stops cold in its tracks then it is likely overloading the circuit or tripping a thermal fuse. Both a big no-no and should be ...
If your pool pump motor start to get noisy, it often means that your motor's bearing are failing and need to be replaced. If a failing bearing is not replaced promptly, the motor can overheat and ...
May 31, 2018 ... While trying to replace the bearings on my Hayward Power-Flo Matrix SP1592 1hp motor, I managed to break the shaft end bell plate due to the ...
Aug 8, 2019 ... You'd want to use a silicone or teflon lubricant on the o-rings & gaskets. Magic Lube makes a good product. You don't need to lubricate the ...
Apr 25, 2020 ... I tried again with the new gasket, this time cleaning off all the silicone and letting it dry. This helped, as it was less likely to pop out ...
