I am looking for a power pcb for a compu pool cpsc 24. What is the part # I am looking for I see you have part # jdpcbscr is this the correct one ? Thanks for the help.
Reply
Hello Jan, From our schematics it appears the correct PCB would be the JDPCBSCR. But I would still recommend contacting compupool at 1-888-989-7258 to make sure that this is the correct board, sometimes it may be the right board just a wrong revision that will not work with your unit.
Reply
Does this a complete board?
Reply
Yes, the JDPCBSCR comes 100% complete. The only thing that will have to be done is to solder the transformer and cell cord wires to the board and screw it down to the base.
Reply
My generator shows no flow or low salt.it's about 2*3 yrs old .The leslies say's the salt is 3200 and the temp.say's 69 deg.everything else works as it did last season.I checked the connections and all are tight.The cell is spotless.from what I'm reading it sounds as if has a bad circuit boar d? thanks for your help
Reply
Hi George, Yes from everything you are explaining it does sound like a bad circuit board. We have a guide here on How to Replace a Compupool CPSC Circuit board which may be of help to you. We also have a guide on How to Isolate and Correct Compupool Problems.
Reply
my salt system is showing water fault or no flow and i have already replaced the cell. which board do i need to fix this problem? the display or the power. thanks!
Reply
Hi Tyler, The Power PCB Board would be the board you would need to replace.
Reply
This board definitely requires soldering. I just replaced mine and I'm still getting no temp reading and a low salt reading. What would you suggest I replace next?
Reply
Hi CD, Verify the salt level by getting your water tested, if the salt level is okay then you may need to replace the cell and or the cable.
Reply
I have a "Aqua Comfort" CPSC CHlorine Generator. Indicates "low salt", but test strip has level around 7000 ppm. Also after powering off generator and restarting same, Generator goes into salt testing, then after 2 minutes it indicates a salt level of 2500 ppm. Cell itself seems fine. Wondering if its the power PCB and if so, do you have a replacement?
Reply
Hello Roy, it looks like this is what you would need, but I would recommend contacting compupool at 1-888-989-7258 to run a diagnostic and to make sure that this is the correct board, sometimes it may be the right board just a wrong revision that will not work with your unit.
Reply
I have an Circupool RJ30 I started getting the 2500/69 reading. I bought a new cell and it worked fine for a few days now it says "no output" and the buttons won't do anything. Do I need to replace both the power and the display boards?
Reply
Hello Dave, we have access to Compupool and not Circupool RJ30 please contact CircuPool® Systems · (888) 908-7784 so that way if there is a part we can provide for you what is needed to repair your unit. Also see if you can troubleshoot and run a diagnostic to see if it just needs to be reset.
Reply
This board is not shown with the SCRs attached. If they are not, are new ones available ?
Reply
Unfortunately these boards are no longer available, I would suggest a completely new system like the PureLine Crystal Pure Salt System.
Reply
