What is the difference between the R0452500 sensor and the R0476400? I've seen them on other websites and the photos & part numbers were the opposite of what this site indicates. Are they both compatible with the Aquapure APUREM w/ PLC1400 cell? Knowing the troubled history with the tri-sensors I want to make sure I have the "latest and greatest" when I upgrade my old Aquapure control unit to the APUREM.
Reply
Russell,If you're replacing the tr-sensor for your APure unit, I would go with part # r0452500, as that is the original sensor that came with your unit. It should say APURE on the sensor itself.
Reply
My flow sensor has died and I need to replace it. The replacement part number is R0452500 but the picture for this replacement part shows show one protruding slit on one side of the sensor and two on the other side of the sensor where it slides into the salt cell. My old sensor and salt cell only have one slit to slide the sensor into the salt cell. Did they change the design? Is there an appropriate replacement part for my salt cell?
Reply
Hello, the R0452500 is part number 2803-085. If you would like to confirm with Zodiac 800-822-7933 about part and design updates.
Reply
Is there any difference between the Jandy PLC1400 sensors in terms of control box compatibility? One has an indicator light box in the cord . The other has a chip at the connection end to the control box board.
Reply
I need to replace the sensor portion only. My model is an AquaPure Model R0452400. The entire salt system was replaced in August of 2015. Could you please advise
Reply
How do i know if i need a new flow sensor on aquapure 1400 or if its the circuit board
Reply
Try this Jandy AquaPure Troubleshooting Guide to help you the source of the problem.
Reply
