What is Service Factor?
Reply
Service Factor(SF) is a multiplier that when multiplied by the horsepower of the motor indicates the total permissible horsepower loading that may be carried when the motor is operating at rated voltage and frequency. The most important thing to remember when replacing a motor is that the replacement motor's horsepower times its service factor must be equal to or greater than the original motor's horsepower times its service factor. The Service Factor rating can be found on the motor label. See Step 4 of our How to Read a Pool Motor Label guide.
Reply
Is there a specific power cord for this pump? I cannot find the replacement cord for this pump. Any help would be appreciated.
Reply
The 3 Prong 115V Power Cord that can be used with this motor P/N is SPX1250WA.
Reply
is there comparable motor for less maybe 1.5 hp I have a 18 round 54in high
Reply
Victoria - You should be able to use a 1 1/2 HP motor for your size AG pool. The comparable motor is Hayward Matrix Pump/ Motor 1 1/2 Hp W/ Switch
Reply
is there a replacement for the bonding lug? the metal strip snapped off the screw that held the lug onto the motor
Reply
Hi Leo, The Grounding Lug (U17-568) can be used with this motor.
Reply
I have a motor sp15201esc, is this motor still available and if so what is the price? Also what is the difference between theses model numbers?
Reply
Is there a replacement switch for this motor?
Reply
Hi Michael, The Hayward On/Off Motor Switch (SPX1500S8) is the replacement switch for this motor.
Reply
I have a SP1520Z1EFTC motor, I don't see it listed in your site. It is 2HP, 115V 1 Phase, R48Y frame with timer board / switch. What do you have for this as a replacement?
Reply
Hi John, This motor us the correct replacement but it does not come with the Timer Microprocessor (SP1500FT), you will have to reuse yours or purchase another one.
Reply
Hi I have Haywood pump with a 2 speed switch that is a 2.0-.25 HP MagneTek century AC Motor that I need to replace. Details on the label indicate Volts 115 AMPS; 16.4/4.4; HZ 60 and RPM 3450/1725. CAT PART 7-193076-01 type CSM. This SPX1520Z1ESC pump looks like it but I would like to be sure before spending $260. Can you confirm this is the correct pool pump replacement?
Reply
Hi Ed, This motor is a little different than your motor, you have a dual speed motor and this is a single speed motor. Your part # of 7-193076-01 cross references to this BN50V1 1.5 HP Dual Speed Replacement Motor the reason the replacement HP does match the 2 HP rating on your Hayward motor is because Hayward used a SPL HP rating where the BN50V1 motor uses a traditional HP rating. The SPL 2 HP rating is equivalent to a 1.5 HP Traditional Rating. The BN50V1 would be the proper replacement for you. We would also suggest replacing your Haward Power Flo Shaft Seal when you replace your motor.
Reply
My pump keeps tripping the breaker. I got this pump from a friend can it be wired for 220 or 110 both if so how can I tell what the pump is set for
Reply
James, I only show this to be a 115/120v motor. What are the amps on your motor label?
Reply
How do I separate the motor from the pump? I have a Hayward SW15941FTTLFP pump with a SP1520Z1EFTC 2hp motor
Reply
Hi, Gerry. You can use the steps in our How To Change The Shaft Seal On A Hayward PowerFlo Pump for the steps needed to disassemble your pump.
Reply
Like Joe's post on 822/16, I have SP1520Z1EFTC but it has broken down. What is the replacement motor for this type?
Reply
Hi Chuck, this is the proper replacement motor however the timer does not come with the motor, you will need to use your old motor. If your timer is broken then unfortunately Hayward has discontinued the timer so you will need to go without a timer.
Reply
I have hayward 2 speed pump part # 7-193347-01 power-flo matrix sp5500z2 (C) looking for a replacement motor. This matrix looks like my pump but does not say 2 speed like mine. Can you help? Thanks
Reply
Hi, Frank. Based on the model and part # provided you will need Item # SPX1515Z2ES.
Reply
I have a power matrix sp5500z2 motor,can I purchase the pump assembly?
thank you
Reply
Hello John, You can purchase the entire matrix pump but they don't make them in the 2hp anymore. They have it available in a 1.5 hp dual speed. http://www.inyopools.com/Products/02200001004959.htm
Reply
Where do I find parts for this pump? I need all bearings and fly wheel.
Reply
Hi. Unfortunately, we do not have a list of parts for this motor. You will have to get the part number form off of the actual part in order to locate the replacement.
Reply
Does the 2hp motor come with the 4 long bolts (about 8 1/4" long)
Reply
It sounds like you are referring to the thru bolts that run completely through the entire motor so yes those bolts do come with these motors.
Reply
Just got my replacement pump but no wiring instructions. do you have a copy or manual that shows wiring to add the plug.
Thanks
Reply
Hi, Michael. A field wiring diagram is located on the motor label.
Reply
I HAVE MOTOR NUMBER SP1520-Z-1-EFTC IS THIS THE CORRECT PUMP? AND CAN I USE THE TIMER OFF MY OLD PUMP BECAUSE IT STILL WORKS? WOULD THE TIMER JUST WIRE IN THE SAME WAY AS OLD MOTOR?
Reply
The Motor 2 Hp W/ Switch (SPX1520Z1ESC, SP1520Z1ESC) can be used to replace the SP1520Z1EFTC SP1520-Z-1-EFTC motor. The Hayward Above Ground Pool Pump Timer Microprocessor - SP1500FT is not included with the motor, they are discontinued. If your old one is working you can install it on the Motor 2 Hp W/ Switch (SPX1520Z1ESC, SP1520Z1ESC). The Tune Up Kit Hayward PowerFlo Matrix Pump - GOKIT74 will need to be replaced when replacing the motor. How To Change The Shaft Seal On A Hayward Matrix Pump
Reply
Would I need anything additional to replace this pump?
-a49ff061-0f05-48d1-a5e5-9c5ebba202fc.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&height=75&width=75&mode=pad)
-a49ff061-0f05-48d1-a5e5-9c5ebba202fc.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&mode=pad&width=650&height=650 "Hayward 2 HP Single Speed Motor with On/Off Switch - SPX1520Z1ESC")
Hi Amber, the correct replacement motor for your motor part number 193824 is the BN50V1. When replacing a pool motor we do suggest a Seal Kit. Could you send us a few photos of your pump so we can suggest the proper seal kit? If so then please take a wide shot of the complete pump to include the pipes going in and out of the pump. To supply photos simply click the reply link below and upload your photos. Once we get those photos we can make the proper recommendation for your seal kit.
Reply
Do you sell a replacement switch for this motor?
Reply
There are two different switches that we sell for this pump. Here are the links...Two-Speed Toggle Switch Assy. - Lo/Off/Hi - 18313301On/Off Motor Switch - SPX1500S8
Reply
Pool pump sp1520z1esc. Just beginning 3rd season . Started pump and it is making a very loud grinding noise, sounds like metal on metal. Pump is currently working but can’t believe it will last long. Question is how do I tell if the problem is the motor,armature, or the impeller and bearings?
Reply
It is hard to 100% know the issue without being there, but the grinding sound you are describing is leaning me towards a problem with the motor of the pump. It would be easiest to swap out the entire motor.
Reply
Is this the right replacement for this label.
-81c1d448-9ab7-49bb-a6e4-37df627a097d.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&height=75&width=75&mode=pad)
-81c1d448-9ab7-49bb-a6e4-37df627a097d.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&mode=pad&width=650&height=650 "Hayward 2 HP Single Speed Motor with On/Off Switch - SPX1520Z1ESC")
I am showing the correct replacement motor for your 7-193824-01 pool pump motor as the...Century 1.5 HP Thru-Bolt 48Y Dual Speed Motor - BN50V1
Reply
I have a Century pump SP1520z1esc 1081, and I am trying to find part number or suitable Strainer Housing replacement. Is there a suitable strainer replacement? I keep getting referred back to hayward.
-24364586-b8d6-4f82-9907-6dc550d5ca2e.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&height=75&width=75&mode=pad)
-24364586-b8d6-4f82-9907-6dc550d5ca2e.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&mode=pad&width=650&height=650 "Hayward 2 HP Single Speed Motor with On/Off Switch - SPX1520Z1ESC")
Hello Mario. The Hayward Motor 2 Hp W/ Switch (SPX1520Z1ESC, SP1520Z1ESC) cross-references to the Hayward PowerFlo Matrix Pump. The Pump Housing Matrix - SPX5500C is a compatible strainer housing. Please reference the Hayward PowerFlo Matrix Pump exploded parts diagram for any additional parts required for your project.
Reply
-7b5593bf-1732-47f5-b190-6c0129a3070a.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&height=75&width=75&mode=pad)
-7b5593bf-1732-47f5-b190-6c0129a3070a.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&mode=pad&width=650&height=650 "Hayward 2 HP Single Speed Motor with On/Off Switch - SPX1520Z1ESC")
-e76bd8d0-c0d2-4098-ba69-2ca469d0c76b.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&height=75&width=75&mode=pad)
-e76bd8d0-c0d2-4098-ba69-2ca469d0c76b.jpg?format=jpg&scale=both&anchor=middlecenter&autorotate=true&mode=pad&width=650&height=650 "Hayward 2 HP Single Speed Motor with On/Off Switch - SPX1520Z1ESC")