Is this part the same as a flame roll out safety switch for a raypak 2100?
Reply
I spoke to Technical help at Raypak ( 805-278-5300 ) and was told that part number 6234-36 is the correct replacement.
Reply
Just wondering what the temp rating is on this part (005899F) thank you
Reply
Hello - I spoke to a technician at Raypak ( 805-275-5300 ) and they said that the temperature rating for item number 005899F is 300 degrees fahrenheit.
Reply
my displat on my heater says rollout sw open. I looked at the fuse and it is not burnt or popped or broken. what does open mean on this part?
Reply
Hello Sean, I would contact Raypak 805-278-5300 to run diagnostic/troubleshooting.
Reply
my heater states roll out switch open what part is that so I can replace it
Reply
That is the thermal fuse. When you open the front of the heater it is the small fuse that has 2 wires going into it and held in with 1 screw. I would also take the top off of the heater and clean out the grate my heater had a lot of leaves blocking the vent and that's what was making my fuse blow. Good luck.
Reply
I have a 2 year old Raypak pool heater, the model number has 406 in it. We're getting a message on the heater that the rollout switch is open, so we figured out where that is inside the heater. I see a lot of identical fuses online, but there's always some letters or numbers that don't match up, including the one you're selling. Mine says 650914/Microtemp/G4AM0609/TF 152C ABA. This agrees pretty much with yours except for the last 3 letters. Is that important? Thanks.
Reply
Hi Judy, thanks for the question! No those last digits will not make a difference and this is the part you will require.
Reply
I have a Raypak RP2100 406K btu digital pool heater and need a new roll out switch - can you provide correct part #?
Reply
Hi, Glenn. This Thermal Fuse - 005899F is also referred to as the Rollout Switch.
Reply
my thermo fuse burned out cause of flame back on fuse whats the cause burned 2 of them
Reply
Hi, Jim. An over-temperature condition, caused by an excessive restriction in the heat exchanger flue passage.
Reply
My ray pack pool heater is only 1 1/2 years old roll out switch popped what is the temp max on switch and part number? My model is p-r206a-en-x thanks
Reply
Hi, Rick. This Thermal Fuse will trip if the temperature exceeds 152C/305F.
Reply
Another question my heater has a slow drip and steams when it comes on. What could psooibly leak at 1 1/2 yrs old. It’s hard to see inside I took off top cover and and both small side panels . It’s a raypak 206a dual control gas heater.
Reply
I need to replace the thermal fuse part # 005899F. Is this something I can do, or do I need to have a pro do it? Does the part come with instructions?
Thanks
Reply
These do not come with instructions and I would not say that you will need a professional to install it. There looks to be a few youtube videos on changing this switch as well that may assist you.
Reply
