I have a Laars Lite 2, Model LG LP Gas pool heater which is approximately 87 or 8 years old. Our pool service company says it needs a temperature control assembly - LG to operate safely. Will this particular Temp. Control Assy., Eps (r0011700 substitute for my heater?
Reply
Hi Jay, Here is the correct Temperature Control Assembly for the Laars Lite LG Series Heater.
Reply
What's the difference in these two parts
6203-071B and 6203-071D? These are the numbers on the back of my part I was told that need replacing LAARS E01174-02
L8005 D 1005
Reply
Hi DJ, The difference is which heater the control works on, the 6203-071B works on the Laars ES, ESII, EPS, EPC-II, and LLD models of heaters. The 6203-071D works on the Laars EG, EPG, ESG, LLG and EPM model of heaters. You should be able to pull one of these model #'s off of your heater.
Reply
I have a Teledyne Lars Model EPC-II heater. Is this part a direct replacement for the Temperature Control unit?
Reply
Hi, Dennis. Yes, this Temp. Control Assy - R0011700 is the correct part for the EPC-II.
Reply
i have a teledyne laars series 1 jacuzzi heater. it has a tendency to initially light up and work at first try then goes on for long periods where only gas odor comes out but wont re-light unless we turn it off and restart the unit. what could the problem be? the igniter maybe and if so which part no? thanks in advance
Reply
It is probably the igniter but typically they either work or not. It could be a ground problem check your ground wires and make sure they are clean and have a good connection.
Reply
I have an old teledyne laars XE ES II 325 dual temperature control pilot saver ignition. Is this the proper replacement? The wire connections look different.
Reply
I have a Teledyne/Laars Mod. # ESC-250P. Is the Temp. Control Assembly # R00117700 the right part for this pool heater?
Reply
need to replace temperature control label on a Laars Lite 2 pool and spa heater for natural gas. Do you have this in stock?
Reply
Hi, William. Unfortunately, the Decal/Label is not available as a separate part.
Reply
I am working on a Teledyne-Laars EPC-II pool heater. Will the R0011700 work as a replacement and is it a direct replacement? If not are instructions provided for the conversion?
Thank you
Hi, Greg. Yes, this is the correct replacement for your model.
Reply
I have a Laars Lite LLD400P which I believe I need a new on/off switch for as the burner tries to light when the switch is in the off position. The units burner is also lighting, then shutting itself down after about 10 seconds, and will then repeat the lighting and shutting down sequence again and again. I would appreciate any advice on parts numbers and what needs to be replaced to correct this. Thanks, Bubba
Reply
