I need a new pressure switch for my Raypak RP2100 Pool-Spa heater that was installed in 1998. Is this the proper replacement pressure switch?
Reply
Yes this would be the correct replacement pressure switch for the Raypak RP2100 Pool-Spa heater.
Reply
is this pressure switch on a Raypak C-R406A-EN-C? If so where is located
Reply
Hi, The Pressure Switch (006737F) would be the correct pressure switch for the Raypak C-R406A-EN-C Heater. It is located at the top of the Inlet/outlet Header.
Reply
Pilot light is on but the burner won't light. Switch is on temp. Switch is up to where heat is called for but will not fire the burner. Is there a switch that tells the unit water pressure is up and it's ok to fire. I need to get this unit running.
Reply
Hello Greg, you might want to troubleshoot with Raypak 805-278-5300 just in case there might be a misc part.
Reply
What is the difference between this model number and the model number in the manual 006737f?
Is 6737f OEM ?
Reply
What is the difference between a 062237B and 062237F. Can they be interchanged?
Reply
Hello, Are there any other part numbers I can reference 062237F by? Nothing is coming up on our website with that part number.
Reply
Is this the correct part to fit the Raypak heater P-R405A-EP? Appreciate your help!
Raypak list a 006737F or 009133F see adjustment is service manual-see www.raypack.com to confirm depending on installation
Reply
Raypak list a 006737F or 009133F see adjustment is service manual-see www.raypack.com to confirm depending on installation
Reply
No, see snip image attached for correct pressure switch part #'s. There are 2 based on the lb rating of your switch.
Just want to be certain, have a RP2100, model R185, installed in this date range. Manual is effective ‘93 and letter is stamped ‘97. Believe this is the correct pressure sensor, please let me know for sure. Thank you.
Reply
Yes, it is the correct replacement.
Reply
We show the pressure switch to be either a 009133F 11 psi ( 47-197-1096 ) or a 006737F 1.7 psi ( 47-197-1462 ) depending on the installation of the heater. Deck level, the 1.7 psi is fine, below water level may require the 11 psi.
Reply
Is this the same pressure switch that would be used in Model PR226A-MP-C?
Reply
Will this work with a 406A (model PR406A-EN-C)
Reply
Hi James, This Water Pressure Switch (Plastic Header) - 006737F will be the correct pressure switch for your Raypak P-R406A-EN-C Heater.
Reply
I have a new Raypak 156A heater.. my heater is below in the basement and tub upon main level... @ 6 ft lower than tub...problem is the pressure switch shipped with the new heater... heater comes on as soon as I put power to it... adjusted turn knob both ways and heater still fires up with out pump running what pressure switch do I need ??? (attached is the original switch) Thanks Dwight
Hi Dwight. This Special Pressure Switch, 11 PSI - 009133F will take care of that for you.
Reply
Is this pressure switch compatible with Raypak pool heater model 2100 006737F
Reply
