Does this part "Raypak Board Controller 010253F" replaces the Raypak p/n 601588 for a 264 btu digital heater? or do I need to look for a different part
Reply
Good morning Ricardo, If you have any of THESE MODELS 185A,185B 206A, 207A 265A, 265B, 266A, 267A 335A, 335B, 336A, 337A 405A, 405B, 406A, 407A that would be the correct board. If not what model heater do you have?
Reply
please show how to hook wires to this control unit
Reply
Hi George This Raypak PC Board Installation Manual should give you this information.
Reply
Does this replace the PC board on the Raypak 2100 digital heater? The part number of the current board is 601588
Reply
Hi, Sean. This will replace the old PCB on the Raypak RP2100 PR185A-PR405A (11/01/98-10/01/03) models. We do not use the actual board p/n but the units model and replacement number as a cross reference guide.
Reply
I replaced the old board in my Raypack RP2100 Digital with a new board. I do not have the LoNox model. The heater fires up for a few seconds, and then stops. There is a code "FAN" that comes up on the display. I believe the LoNox model includes a blower fan, but mine does not have the blower fan. How can I resolve this issue? I saw that there were break-out tabs on the board. I have not broken any of the tabs. Thanks.
Reply
Hi, Ron. From your last question or explanation, check the wiring of the new board and your unit with the Raypak PCB Board Replacement Instructions.
Reply
I have a doughboy pool w a raypac heater. Model number P-R 185A-EN and serial number 010908904. Wondering if your part number 010253F will fit as replacement. Thank you . Linda
Reply
Hi. This will be the correct replacement PCB for your model unit.
Reply
I am getting an error code EOL (End of Line) which is a factory use code. What does it mean?
Reply
Hi, John. “End-Of-Line” is a test conducted by Raypak before the heater is shipped. We connect water, gas and power to every heater and every heater is fired and functional. To exit EOL test and select OFF press MODE Button.
Reply
Hi, does this board replace 601769?
Yes this is the proper replacement for the 601769 board or you may also use the 013464F Raypak Board. We would suggest the 013464F Raypak Board since it is a little bit of a newer design over the 010253F and is less expensive.
Reply
I ordered your replacement board and installed. Now I get CFH, then it sits on spark and nothing happens. Usually the animated spark icon at the right of the LCD panel will show spark/flame. But I get nothing... any suggestions or thoughts?
Reply
Hello, We recommend contacting the manufacturer with that question, you can reach them at 805-278-5300.
Reply
If this has still yet to be resolved, then If you can get a visual, is the pilot lighting?
Reply
When will this be available again? Ours burnt up and needs to be replaced. Also, do you know why it may have burnt like that? I would hate to replace it only to have that happen again!
