Hello. Which side is the standard placement for electrical wires for led strip? If I am facing the rear of the waterfall, is the standard electrical placement left or right? I am hoping you say left. Thx!
Reply
Hi, Mark. The Brillant Wonders Waterfall is capable of accommodating the electrical conduit on either side.
Reply
What else do I need to buy to make this waterfall with LED light work properly (in addition to the LED remote controller described in the manual? What size pump do I need (the waterfall will be 3' above the water line of the pool)? Do I need to buy a secondary filter (in addition to the main filter for the pool)?
Reply
No you do not need to have a second filter and you maybe not to get a second pump for the waterfall. What is the distance for your current pump to where the waterfall is going to be.
Reply
My pool plan shows separate drains for the waterfall in the pool, but I do have not seen the requirement for drains in any of the installation guides. Do I need to add drains just because I am using a waterfall? Or will my two main pool floor drains and skimmer be sufficient (seems so to me)?
Reply
Your current drains will be sufficient enough for your waterfall, no need to add an additional drain.
Reply
I have a new pool being constructed and have a 2" stub out for a water feature.
Please decsribe how I would install this in newly constructed cinder block wall with regard to plumbing and electrical.
Reply
Laurie, There are some photo examples of that in the owner's manual (starting at section 3.1.1). Please note that the lip must be supported as shown in the illustrations.
Reply
I WANT TO PUT MY WATERFALL ELEMENT AT THE EDGE OF THE POOL WHAT IS THE RECOMMENDED DISTANCE FOR INSTALLATION FROM POOL EDGE . IT WILL BE INSTALL 6'-00" FROM POOL DECK LEVEL
Reply
Hi, Andre. The wall depth will have to be 10"-12" in order to house this waterfall.
Reply
