Part # 5032-51
Manufacturer Code 805-0238
Dimensions 3-1/2" ID, 1/8"
Diffuser O-ring - 805-0238
1 to 2 hrs
Screwdriver, Nut Drivers, Socket Set, Wrench Set, Adjustable Wrench, Silicone grease
Shut off power. Removed 4 bolts holding pump and motor together. Disassembled impeller, diffuser and pump face. removed old seal, installed new pump shaft seal parts as well the diffuser rubber O-ring. Used copious amounts of silicone grease on O-ring replacement!
Less than 1 hr
Screwdriver, Nut Drivers, Pliers, Socket Set, Wrench Set
2 0
Step 1: I read the q+a at inyo pools for a pump seal for my waterway pump, and inyo recomended this seal along with the faceplate gasket and pump seal, and thank goodness for that as this seal was leaking, and the faceplate gasket was just a huge wad of silicon sealer.
2: unplugged pump, removed ground, closed filter and feed valves.
3: removed lines from pump housing and removed pump
4: remove 6 faceplate bolts and split pump from motor. At this point diffuser o-ring gasket can be removed, area cleaned, and new o-ring installed.
5: if that is all you are replacing, reverse steps now and put it all back together.
The Most Recent Reviews
(5 out of 5 stars) Diffuser O-ring fits perfectly!
Reviewed By: Inyo Customer ()
Fit perfectly! High quality rubber exactly like the quality of the OEM gasket I replaced.
Was this review helpful to you?
(5 out of 5 stars)
Reviewed By: Steven P. ()
right part good price
Was this review helpful to you?