Part # 4802-03D
Manufacturer Code GMX600NM
Dimensions 9-5/8" x 4-1/8"
2-piece black Noryl plastic clamp by CMP used on various Hayward top mount sand filters including Sand Master, Swim Pro, Pro Series Top Mount and E-Series. Clamps the filter valve to the tank. Part number GM600-NM is molded into each half.
Clamp components:
Additional dimensions:
Can you buy just the bolts without buying the whole flange clamp?
Reply
The bolts are not sold separately, you may be able to find suitable replacements at a hardware store. If that option does not work then a assembly would need to be purchased.
Reply
Will the Hayward GMX600NM clamp replace the Praher TM-12 Clamp
Reply
Hi Stan, The clamp is actually part of the filter so we would need to know which filter you have to know which clamp you need. If you do have a Hayward top mount sand filter like the S166T, S180T, S210T or S244T then the GMX600NM clamp would be the correct clamp.
Reply
Will this clamp work on a S244T Pro Series top mount sand filter produced in the 1990's? What about the other parts, will they work to replace parts on the filter sold in the 1990?
Thank you
Reply
Hi B., Yes this is the correct clamp for a Hayward S244T Pro Series Sand Filter. The parts on the Hayward Pro Series Sand Filter Exploded Parts Diagram would be all the correct parts for a S244T sand filter from the 1990's.
Reply
Will this clamp fit a monarchpoolsystem filter tank Serial No FL074458 Model No S21.The opening is 254mm across. Thank you.
Reply
Hi, Unfortunately, I was unable to find any info on the Monarch Pool Systems that will confirm if this Flange Clamp will work.
Reply
Less than 1 hr
Screwdriver, Pliers
4 0
This was easy for me! I'm not good at DIY repairs. I've only had my pool 3 seasons. It was here when I bought the house.
The valve clamp cracked in half and there was water pouring from the filter.
1. I unscrewed the old valve clamp 2.Put the new valve clamp in place making sure the entire clamp was secured around the whole diameter. 3. Then tighten the screws on both sides. That was it and my filter is working great now.
Less than 1 hr
Screwdriver
4 1
Very simple install, use a large screwdriver (Philips or flathead), and remove the old flange by unscrewing two small screws, remove old flange. Install new 2-piece flange starting by placing the two flange pieces around the joint between the top of the sand filter and the bottom lip of the filter. set the square nuts in the flange and thread the bolts through both flange piece, and tighter 1/2 way.
Repeat on other side and then alternating each side tighten flange is fully tight. Turn on system and test, making tightening adjustments to the new flange bolts. Once no leaks are seen, apply the small rubber bolt ends to the bolts to keep from corroding. Very easy install.
The Most Helpful Review
4 0
(5 out of 5 stars) Do It Yourself
Reviewed By: Inyo Customer ()
Solved my leak problem.
Was this review helpful to you?
The Most Recent Reviews
4 0
(5 out of 5 stars) Hayward Healthy
Reviewed By: Fogertyclone ()
Quality parts as always!
Was this review helpful to you?
4 0
(5 out of 5 stars)
Reviewed By: Inyo Customer ()
PROMPT DELIVERY
Was this review helpful to you?
4 0
(5 out of 5 stars) Correct part
Reviewed By: Joe V ()
Pros: Correct Part
Plastic parts with sun exposure will eventually break. This was shipped on time and correct.
Was this review helpful to you?