Model # EC-160354
Warranty Ecommerce (EC) products: Products purchased from an Authorized Pentair Online Reseller (products beginning with EC-) receive a one (1) year (parts only) warranty from the date of purchase. The exceptions are: IntelliChlor cells and IntelliFlo SVRS pumps which receive a two (2) year warranty. EC products are not eligible for the bundled three (3) year extended warranty.
Alternate Part #'s 160354, CCRP 100, CCRP100, EC160354, PAC-05-0094, PENEC-160354
The Clean & Clear® RP Cartridge Filter has a side entry port, which provides nearly 50% more efficiency than any other single cartridge filter available. Inside, the Clear & Clear RP has increased cartridge surface consistency to block and trap particles as small as 20 microns.
FEATURES
NOTE: Actual system flow will depend of plumbing size and other system components.
Pentair Pool Products does not recommend flow rates above 150 GPM
I have a Hayward sand filter that has crack - 2nd one - so I'm done with that. I'm looking to upgrade to a cartridge filter. I have an old pool - 23k gallons. 1hp single-speed pump with 1.5 inch pipe, so I'm limited to 44gpm flow. Would this filter be large enough as a minimum size filter? Thanks for the help.
Reply
If the pump is pushing 44GPM at 50' of head, yes, the Clean & Clear RP Cartridge Filter 100 sqft. - 160354 will be a great choice for the pump and gallon size of the pool. You are welcome to provide the pump wet-end model number and we will review it.
Reply
hi, would this work ok with a pump that does 320 lpm thankyou.
Reply
How does the clean&clear 100 compare agaisnt the rp version. I'm replacing my Hayward 90 on a 10k pool with an pentair vs pump. I know either will fit just want to know the difference.
Reply
Hi, Derek. The RP models maximize flow efficiency and ease of installation.
Reply
How to drain water from pool through the filter?
Reply
You can install a 1.5-inch spigot on the drain port then attach a water hose so you can drain in when the pump is on. Or you can add a 3-way valve in the plumbing before the filter and attach a backwash hose to that.
Reply
If the center core lifts out when removing the cartridge, is there a particular way it must be reinstalled?
Reply
Hi, Ray Hardy. The Center Core can only be installed one way. You will have to line up the groves with the grove in the tank body.
Reply
Need to drain water off pool do to excessive rain do you make a hose to fit drain valve?
Reply
These filters have a 1.5 inch drain port that you can thread a water spigot to then attach any standard water hose to for draining. You can get these spigots from any local hardware store.
Reply
2 to 4 hrs
Pliers, hacksaw
1 0
Shut off pool timer and tripped breaker
Drained water from old smaller filter
Took picture and marked influent & effluent lines
Cut pvc pipe to filter and removed old filter
Placed larger filter into position
Original pvc pipes did not line up
With multiple fitting made corrections to piping
Using 90* sweeps and couplers dry fit all new connections.
Leveled new filter into positions and adjusted piping.
Marked pipes to ensure proper locations prior to using pvc primer & glue.
Made all connections and allowed for glue to set.
Filled new filter and checked for leaks.
Flooded new pipes as well to check for leaks
Installed new cartridge into filter
Replaced filter cover, primed pump
Breaker and time clock on
Released air in filter at vent
Checked for leaks again
New filter system installed and works great.
The Most Recent Reviews
(5 out of 5 stars) Much better pressure and long-term filters work so much better than older TEAL filter housing.
Reviewed By: Inyo Customer ()
Replaced a very old TEAL 100 sqft. filter housing that took filters that were getting very hard to find and super expensive. Typically the old replacement filters only lasted about 4 months and cost me 4X what the filters for this filter housing cost. A little tricky to get the housing open at first, but applying pressure on one side while pulling up and twisting got it open. So much better than our old housing and only required 3-4 hrs to replace and adopt the pipes to match.
Was this review helpful to you?
(5 out of 5 stars) Clean looking, efficient
Reviewed By: Inyo Customer ()
I replaced a tired old DE system with this unit. It is clean looking, efficient, super easy to DIY install, and the staff at INYO were available immediately to offer support and recommendations for sizes and application. It has been in system for 1 month with 0 problems.
Was this review helpful to you?