Jandy Stealth SHPM 1.5 impeller broke

Written on 7/7/2021 by Guest

To replace the impeller is not a problem, the real problem is not having your filtration system not running for a week while you are waiting your part to arrive.

I have created a back system that I can plugin on the piping of the pool equipment where the Jandy pump goes without any new piping.

1) I have used two 3" x 2" rubber connection with metal clamps in both ends
2) Small pump 1HP 1 1/2" inlet/output
3) 1 1/2" PVC pipe (2 feet just make cut of parts needed)
3) 1 1/2" rubber 90" connector with metal clamps in both ends.
4) 2 PVC reduction 2" slip in to 1 1/2" slip in
5) 45 angle 1 1/2" slip in

* Connected 3" x 2" with clamps into the pipe where the Jandy pump was attached
* place the adapter 2" x 1 1/2" in the rubber connector
* connect the 1 1/2" adapter from the pump inlets
* connect the 90 degrees rubber connector into the 1 1/2" pump outlet adapter.
* connect the 3" x 2 " rubber adapter into jandy CS200 filter using the 3" side
* on the 2" side place adapter 2" x 1 1/2"
* clue a piece of pipe on it
* now use the 45 degrees making adjustments to connect to outlet of the pipe

Now I have a back pump, that works plug and play on the pipe of the pool equipment.

Were these instructions helpful?