It appears that your browser has JavaScript disabled:
To provide the best experience on our website, we require your browser to have JavaScript enabled.
Here are the instructions for how to enable JavaScript in your web browser.
Once you've enabled Javascript, please refresh this page.

Or give us a call at 407-834-2200, and we would be happy to take your order by phone.

How To Wire a Hayward AquaRite on 115V

WRITTEN BY: Inyo Pools

5 out of 5 stars on 1 ratings
(Click on a star to add your rating)

This guide provides a step-by-step procedure for wiring a Hayward Aqua Rite on 115V. Note: This guide is intended to give you a visual reference to supplement the Hayward owner's manual, not replace it. Make sure you read and understand your owner's manual before installing your unit.

Step by Step

Top

Step 1

TURN OFF POWER at the breaker.

Step 2

Open the Aqua Rite control box and remove the two screws that secure the blue cover panel.

Step 3

Remove the blue cover panel.

Step 4

Locate the metal jumpers on terminals 2 and 3 on the main circuit board. With a phillips head screwdriver, loosen the screws on terminals 2 and 3. Slide the jumpers out. One jumper will be stacked on top of the other.

Step 5

Loosen the screw on terminal one and slide one jumper onto terminals 1 and 2. Tighten the screw on terminal 2 and leave the terminal 1 screw loose.

Step 6

Loosen the screw on terminal 4 and slide the other jumper onto terminals 3 and 4. Tighten the screw on terminal 3 and leave the terminal 4 screw loose.

Step 7

Remove one of the knockouts located near the wiring connections of the Aqua Rite control box.

Step 8

Thread a 1/2" mpt terminal adapter into the knockout of the control box.

Step 9

Feed the cables through the terminal adapter and into the Aqua Rite control box. There should be one hot line (black), one neutral line (white), and a ground line (green).

Step 10

Connect the black (hot) line to terminal 1 and tighten the screw.

Step 11

Connect the white (neutral) line to terminal 4 and tighten the screw.

Step 12

Connect the green (ground) line to the green screw and tighten it.

Step 13

Move the blue panel back into place and tighten screws.

Step 14

The last step will involve bonding the AquaRite box. Using an 8AWG conductor, connect the grounding lug on the underside of the AquaRite to an appropriate earth contact. Failure to adequately bond your power unit can lead to severe electrical shocks. For more information about bonding, check out our guide titled "How to Add a Line to the Pool Bonding Wire".

Step 15

Turn power back on at the breaker. Your AquaRite should now power up on 115v.