Part # 4652-03
Manufacturer Code 447
Predator/Clean and Clear Tank O-ring - Generic
OUTSIDE DIAMETER: 9-1/2" INSIDE DIAMETER: 9" THICKNESS: 1/4" THIS O-RING MAY LOOK TOO SMALL BUT IT IS THE CORRECT SIZE IT IS MADE TO STRETCH A LITTLE WHEN IT FITS AROUND THE BODY
The O-ring on my filter/pump is 12"x 1/4" in size. It is a Predator filter with a Tropica pump. I found one in the separation tank area. Will this O-ring fit my filter?
Reply
This is the correct o-ring for the Predator cartridge filter lid.
Reply
I replaced the large 9.5 inch O-Ring on my pentair warrior filter and it still leaks, but only on one side. The O ring fit very tight had to streach it a bit . Is there more than one size, you only show one.
Reply
I want to purchase this O ring and just before I do I want to make sure it is for
Pentair model no. 160354 so I do not order the wrong thing.
Mine says Clean and Clear but i do not see the work Predator on it anywhere.
I would appreciate a reply at your earliest convenience so I can order it.
Less than 1 hr
None
Shut off electricity to water quality system
1. Close inlet and outlet filter valves.
2. Vent filter and drain to point below o-ring
3. Remove locking ring and filter cover.
4. Remove existing o-ring
5 Coat new o-ring with with o-ring lubricant and install on filter body
6. Install cover and locking ring.
7. Refill filter, venting air until a bubble free stream is obtained.
8. Close vent, and open inlet and outlet valves.
9.Project is done.
The Most Helpful Review
1 0
(5 out of 5 stars) O Ring Seals the Deal
Reviewed By: William C. ()
After trying several other products that allegedly fit, this one finally did it.
Was this review helpful to you?
The Most Recent Reviews
(5 out of 5 stars) Perfect fit!
Reviewed By: o rings from cleveland ohio ()
Pros: perfect fit
Was this review helpful to you?