Will i need any other parts when I change the body?
Reply
Hello Mike. There should be nothing that is absolutely needed when changing out the pump body. The only thing I would suggest is changing the backplate o-ring 5020-136 and the diffuser o-ring 5020-116 . As long as you are inside, this is a good time for a little preventive maintenance
Reply
Are the pump suction and discharge connections located such that pipe modifications would not be required?
Reply
Douglas, No modifications will be needed since this is the exact pump housing used with your pump model.
Reply
I bought a replacement o-ring for my Jandy stealth spin on lid. Two o-rings came with the lid. Do I use BOTH o-rings???
Reply
Hello, yes you will need both seals as one sits under the lid and the other sits at the top of the trap body.
Reply
Does this fit the SHPM2. O 2 and does it come with the connections for piping.
Reply
Hi George, yes this is the correct pump body for the Jandy Stealth SHPM pump series and does not come with the unions. There are two union options that you can view on key 11 on this Jandy Stealth SHPM parts diagram.
Reply
Are the drain plugs included?
Reply
Hello,Thank you for contacting Inyopool products! Unfortunately, the drain plugs are not included with this pump body. You can find the drain plugs by clicking the part number below. Part number - 5020-111
Reply
Will this pump body fit model shpf3.0 ? The suction and discharge lines are 2.5”/3.0” on the shpf3.0 I believe
Reply
Hello, yes the Pump Body - R0445601 would be the correct replacement for the Jandy Stealth SHPF & SHPM Series Pump (2008-Current).
Reply
I did not see a gasket kit for the backplate and the inlet and outlet.
Reply
Hello Raj,The seal kit for the 5020-130 is a GOKIT77SHP. If you need the inlet/outlet O-rings they are 5020-137. They are sold separately from the tune-up kit.
Reply
