By Pentair Pool Products
Part # 6290-466
Manufacturer Code 77707-0013
Dimensions 11" L x 9" W x 9" D
Control Board Enclosure/Membrane Panel Kit - NG/LP Series - 77707-0013
have a sta rite pool heater. can't adjust temperature up or down using buttons. does it require replacement of membrane panel kit? is it something i can do myself?
Reply
Hi Larry, Normally issue would be a bad membrane kit or the Max-E-Therm Control Board. I would double check with Sta-Rite (now Pentair) at 1-800-831-7133 to confirm which part needs to be replaced. The actual replacement is pretty easy the hardest part is troubleshooting which part needs to be replaced.
Reply
heater wont fire up replaced membrane and stack sensor still getting E06 mssg ...do you think control board out again this is 2nd one or third one in 14 years heater worked fine before... just wont fire this season
Reply
Hi Mike, It's possible that the Heater Control Board is bad again. The only way to confirm is to replace it.
Reply
im in the same boat as Larry. I want to replace this membrane to start. how does it come off? I see a pin on the edge of the underside photo...?
Reply
Hi, Joe. Removal step are located on page 27 (Control Panel Indexing) of the Max-E-Therm Owner's Manual.
Reply
Hello
I’m looking for a replacement part for my sta-right / pentair , it looks exactly like this! Only my serial number is SR400NA will this work in place of it? They are Identical ! Number of buttons number of controls everything just the two serial numbers are different..
Thanks ...
Hi Gabe, yes this kit is compatible with the Sta-Rite Max E Therm heater model SR400NA.
Reply
