By Hayward Pool Products
Part # 5112-039
Manufacturer Code SPX4000S
Dimensions 7-3/4" ID, 1/4" Cross Section
Strainer Cover O-ring (2008-Current) - SPX4000S
7-3/4" ID, 1/4" Cross Section, Generic
Disclaimer:
All manufacturers’ names, brand names, trademarks, images, symbols, descriptions, and part numbers are used herein for reference purposes only.
Cover no. ST4000DT......PLS. SPECIFY CORRECT COVER O' RING
Reply
Hi Tom, If you have the SPX4000DLT, you will need the T-Ring (SPX4000TS).
Reply
I need a replacement strainer cover gasket for a Hayward NorthStar SP 4000ZL1 it is prior to 2008 around 2003
Reply
Hi, Bob. The CX400G O-ring are used with the models prior to 2003. If you can provide the p/n off of the cover you have we can locate the correct o-ring.
Reply
I have a Hayward NorthStar pump - SP4010X152NS. I need a new o ring for the strainer cover and just wanted to make sure that the 2008 to current is the correct one to buy. Please advise.
Reply
Hi Kate, The lid o-ring varies based on the year of the pump. Do you know approximately when the pump was installed? Could you send us a few photos of the lid? Are there any part #'s that are embossed into the plastic part of the lid if so can you supply those to us? To send the photos simply click on the reply link below and upload your photos.
Reply
What is the year of mfgr on your pump?
Reply
Gents,
i have the SP4010X15NS,and the lid has the mark SP4000T. Now, I already have the T ring on it brand new, but around the edge of the pump, i can see that an O ring can go there. What other O rings can i try for this version?
Reply
The SP4010X15NS confirms to be one of the Hayward NorthStar SP4000 Series Pump (1998-2007) The O-ring, Cover - 367 is for pump prior to 2003 and the T-Ring, Strainer Cover - SPX4000TS is for 2003 to current pump models.
Reply
