By Raypak
Part # 6238-014
Manufacturer Code 009577F
Dimensions 5.5" L x 4" W x 2" D
3 WIRE, GREEN, GREEN, BLACK
Is there a quick reference or instruction guide for installation of the temperature sensor,IID unit?
Reply
Hi Bob, Page 11 of This Manual may help.
Reply
My inground pool heater says sensor failure and will not start. Where is the problem and how do I fix it?
Reply
Could you let us know the make and model of your heater and approximately how old it is?
Reply
I have a Raypak pool heater, model P-R335B-EN. It has stopped heating and has a fault code SNS - sensor. What is the replacement part number and the cost? I have no manual could send me a copy?
Thanks
Reply
Hi, Larry. Based on the model number of your unit and the error code, you will need to replace the Temperature Sensor - 005088B.
Reply
I have a 2014 Raypak 406a. The display shows sensor failure and the unit will not work. The display is still showing water temp correctly. Is this a temperature sensor failure or is there another sensor? Thanks
Reply
Hi, Todd. If the unit is reading the correct temperature, the sensor may not be the issue but the circuit board. I would recommend troubleshooting the unit using the Steps on Page 46 of the Raypak Owners/Instructions Manual.
Reply
I have a Raypak P-R266A-EN-C pool heater. I am getting SNS error code. Do you carry a replacement sensor for this model? Is this part easily replaced by an HVAC licensed contractor? Or should I consider purchasing a new heater?
Reply
Hi, Karenlee. We do sell the replacement Temperature Sensor - 009577F for your unit which can easily be replaced by an HVAC licensed contractor. I would not recommend replacing the unit if the temperature sensor or circuit board is bad, they can be replaced.
Reply
