Part # 5019-22
Manufacturer Code 319-4100B
INYO # 5019-22 WATERWAY# 319-3260 WATERWAY STRAINER LID CLEAR, ROUND LID WITH 2 EARS, ONE ON EACH SIDE USED ON MULTIPLE PUMP STRAINER HOUSINGS LID IS CLEAR AND HAS 4 SLOTS EVENLY SPACED ON THE TOP 2 1/4" LONG THIS ALSO HAS 6 RIBS MOLDED IN OUTSIDE DIAMETER: 7-3/4" MAXIMUM FROM EAR TO EAR: 9-1/2" HEIGHT 7/8" "319-3260" IS MOLDED INTO THE BOTTOM OF ONE OF THE EARS, VERY HARD TO SEE NOTE: THIS IS VERY SIMILAR TO THE 5032-39 SVL STRAINER LID BUT IS SMALLER.
This New Style lid replaces either of these old-style lids.
New Style Lid Old Style Lid version 1 Old Style Lid version 2
I need the oring that fits to this lid, any ideas?
Reply
Hello Richard, I believe the lid you need is the Lid O-ring, 6" 5050-14A.
Reply
I need the strainer housing but the only part # i can find is on the lid. Any idea how I can find out which housing I need as I see there are several different ones. My lid has the part #319-3260. Its a waterway pump by the way
Reply
Seth, This lid can be used on several different Waterway Pumps. If you can send us photos of the housing I can try to locate the correct housing.
Reply
How would i know if my trap is full? Will the water stop flowing into the pool.
Reply
The water will definitely slow down, depending on how full you are talking about. It is better for the motor if water not flowing does not happen. It would put unneeded stress on it and possibility cause the motor to fail prematurely. If you see a decrease in the returning water, please empty the basket as soon as possible.
Reply
This product is no longer available, is there a substitute?
Reply
Hi Roy, We researched this lid and found that the 319-3260 was replaced by the 319-4100 and this lid is a direct replacement. So we have re-activated this product and when placing an order we will ship the new 319-4100 lid which is shown in the photo on this page.
Reply
We have the above ground hi flo pump it is a replacement for the original pump, We are having problems with when I connect the vacuum hose it sucks air. I googled the problem and found finally an answer that fits our issue. They said that the o ring in the filter basket/lid needed replacement and that fixed it. I see this replacement is made a bit sturdier than our lid. Does it also come with the o ring? we have been afraid the lid might break so I thought I should just get the whole lid in case
Reply
Hi Sue, The Waterway Hi-Flo Lid (319-3260) does not come with the Lid O-ring (5050-14A) it is sold separately. You can start with replacing the lid and o-ring to see if that will solve your problem.
Reply
The Most Recent Reviews
(5 out of 5 stars) perfect locking system on the cap
Reviewed By: Johanna H. from clemmons,nc ()
i have a mirana above ground pool that is 8 yrs old. i am starting to replace parts due to the age of pool. some parts are hard to find. this lid is exactly what i was looking for and better than the old one
Was this review helpful to you?