Part # 5069-05A
Manufacturer Code 05386305R
Dimensions 3.75" X 0.25"
INYO # 5069-05A JACUZZI # 05-3863-05-R THIS IS A 1 HP IMPELLER USED IN THE J, JCM, AND B SERIES BLACK PLASTIC IMPELLER INCLUDES: IMPELLER ONLY CLOSED FACE NUMBER OF VANES: 4 OUTSIDE DIAMETER: 3-3/4" THICKNESS: 15/32" (OUTSIDE THICKNESS AT OUTSIDE EDGE) THICKNESS: 9/32" (B) (INSIDE THICKNESS AT OUTSIDE EDGE) FRONT TO BACK: 3-1/4" (FROM END OF SHAFT TO FRONT ON INTAKE) INLET OUTSIDE DIAMETER: 2-1/16" INLET INSIDE DIAMETER: 1-13/16" SHAFT COVER LENGTH: 1-1/2" SHAFT COVER OD 5/8" (THIS IS WHERE THE IMPELLER SCREWS ONTO THE MOTOR SHAFT) MARKINGS: 05386305 IS WRITTEN ONTO THE IMPELLER FACE IN INK
In which direction does this impeller unscrew from the motor shaft?
Reply
The impeller unscrews counter clockwise. Our How To Replace A Pool Pump Impeller Guide may be viewed here http://www.inyopools.com/HowToPage/how_to_replace_a_pool_pump_impeller.aspx
Reply
Less than 1 hr
Screwdriver, Nut Drivers
Shut water valves, and drained filter. Removed pump from filter. Opened casing with four screws. Popped off back grease cap wth flathead screwdriver, held shaft in place with big flathead screwdriver, unscrewed remaning portion of impeller, popped old ceramic out of housing. Added new ceramic in housing, not touching it with fingers (oils aren't good for the ceramic), replaced new pump seal on impeller, screwed new impeller onto shaft through housing, holding shaft in place with big screwdriver, added four screws, replacing housing. Reconnected pump to filter. Opened valves, cleared out air pockets from filter, ran pump, checked for leaks, put on bathing suit, enjoyed pool!
