Part # 7790
Dimensions 15" L x 0.2" W x 0.2" D
Temp Sensor Kit Gray (Air/Water/Solar) 15 ft cord.
The picture does not show an o-ring on the sensor or a pipe clamp. Does it come with these so I can install it directly in a pipe?
Reply
This temp sensor does not come with an o-ring or a pipe clamp. To install you can buy those separately or use the existing o-ring and clamp from your old sensor.
Reply
Hello, my heater system is the Jandy LXi for a salt water pool. Is the water temp sensor I need to replace called the 7790. My parts book states RO477300. ALso, the location is directly downstream of the pool pump. Do you consider that the optimum location for best readings?
Reply
Hello Charles- The Temperature Sensor (Salt) (R0477300) NO LONGER AVAILABLE REPLACED BY R0456500 is Discontinued and no longer available. It has been replaced by the Lxi Temp Sensor W/sleeve & Gasket (r0456500) 6204-208. Both of these sensors are for the temperature of the water and are installed in the headers of the heat exchanger as seen in this parts diagram: http://www.inyopools.com/parts_jandy_legacy_model_lrze.aspx.
Reply
The Most Recent Reviews
(5 out of 5 stars)
Reviewed By: Inyo Customer ()
I get about 5 to 8 yrs of service out of one. I have a salt pool.
Was this review helpful to you?
(5 out of 5 stars) sensor as is described and working well
Reviewed By: Stephen R. from Bonita springs, FL ()
Pros: it works
Cons: none
had greatest experience and support…no problems here
Was this review helpful to you?
(5 out of 5 stars) No problem temp sensor
Reviewed By: jimmy from The Woodlands, Texas ()
Hooked it up and it works!
Was this review helpful to you?