Part # 6238-121
Manufacturer Code 009839
INDOOR STACK KIT, R266A, R267A
I presently have a 7" in-door draft hood. Heater model R206A calls for a 6" flue diameter. Can my existing 7" draft hood be used with the R206A?
Reply
Ed, If you have the Raypak 206A heater, you will need the matching In-door stack top. You would not be able to use your existing one.
Reply
My original heater had 8" stack. The R266A calls for 7" draft hood. If I purchase your 6238-121 stack kit, is there adaptor that goes from 7" to 8" so I can adapt it ro my roof stack, if so do you stock it?
Reply
Walter, There is not an Hood Adapter that will make the hood vent 7" to 8" that i'm aware of. You can contact RayPak at 805-278-5300 to see if they have such an adapter.
Reply
Would this fit my P0280N raypak gas heater? I need to convert from an outdoor heater to an indoor heater. I am in sydney australia also. Thank you, Beau
Reply
Hi, Beau. I was unable to locate any info confirming if this Indoor Stack Kit will fit model # P0280N because that is an Australian model.
Reply
The heater kit you show for my Raypak 266A consists of a stack, a square plate with a hole in it and 3 clips. Does the square plate go on the inside just above the coils or does it sit on top of the heater.
My Raypak 403A that I am replacing was equipped with an outdoor stack but it had a square plate on the top of the heater and one inside the heater just over the coils which supported the stack. I'm somewhat confused.
Reply
Hello Michael. Raypak has an Installation Video on their Raypak YouTube Channel - Indoor Stack for Gas-Fired Heaters. Raypak® Indoor Stack for Gas Fired Heaters - Training Video Attached please find the Installation and Operation Manual for the Raypak Gas Heater Model 266A. Please note the information contained on page 11. INSTALLATION AND OPERATION MANUAL
Reply
