Replacing Ray-vac venal hose

Written on 6/25/2020 by Guest

1. Make sure pool pump is off
2. Remove hose section to be replaced by sliding up the mender sleeve cover and removing C-clip at the hose couplers on each end of the hose.
3. Remove hose ends from hose couplers.
4. Place the toothed ring of the mender sleeve kit over the end of the replacement hose.
5. Slide the cover ring of the mender sleeve kit onto the hose coupler -small opened end first.
6. Gently work the hose end onto the hose coupler until the toothed ring is completely past the nob on the end of the hose coupler.
7. Slide mender sleeve cover over the toothed ring until there is enough room on the hose coupler to fit the C-clip.
8. Replace C-clip in the space between the mender sleeve cover and the shoulder of the hose coupler.
9. Repeat steps on the other end f the replacement hose

Were these instructions helpful?