Part # 3280-05
Manufacturer Code EC86
Dimensions 8.25" L x 3.75" W x 3.75" D
Turbine Drive Shaft - EC86
Complete turbine drive. Includes 2 shafts per pack.
Our 4 wheel cleaner isn't moving properly. The wheels get stuck and it eventually goes in circles when trying to clean. Any part suggestions that would help fix this?
Reply
Hi, Kelli. In order to assist you, I will need to know the make and model of your cleaner.
Reply
1 to 2 hrs
Screwdriver
I noticed my Letro Legend going in circles at the deep end of the pool recently. So after 10 years of neglect I pulled it out of the water and took a look. Not only were the front drive wheels missing teeth in some places but the drive shaft itself was worn down.
So I ordered new bearings, turbine shaft and spacers from the schematic on INYOPools. Replaced those parts and moved the back wheels to the front. Problem solved. I doubt however that it will go another 10 years without additional attention to the wheels and bearings.
HINT: Make sure you mark which holes in the bottom have weights after removing the bottom cover. These don't show on the schematic and aren't listed as parts you can order.
The Most Recent Reviews
(5 out of 5 stars) Turbine drive shaft
Reviewed By: Jorge L. from Dallas, Tx ()
Pros: Simple to replace
Cons: Cost
Since replacing on a 4 yo pool sweeper, it's like having a new one. It was very easy to replace and all parts fit together nicely and snugly. It's amazing to note how worn the grooves had become.
Was this review helpful to you?