Part # 2512723-001
User Interface Off-Board Mounting Kit - 2512723-001
For added convenience, the V-Green 270 user interface can be remotely mounted. Kit includes all the necessary components to mount the 270 user interface to a wall, deck post, or other surfaces, including accessories to seal the controller unit to protect against the elements.
Kit Includes:
I would like to mount the controller in a covered area. I will need 10-15 feet of cable.
If the cable is not long enough can I use a standard 24 gauge wire?
Reply
Yes if the cord provided does not reach the area needed you can use a different wire to make the connection.
Reply
If I mount the user interface remotely, use a longer wire and the existing connectors that come with the pump as suggested in the manual (page 31,32), will that void the warranty? Page 33, says while an optional kit is offered to mount the interface remotely "it is not mandatory to purchase this kit to mount the User Interface remotely." and it does not say here you will void the warranty if you do. The previous answer says you can use a different wire if a longer run is needed.
If you need to use a longer wire from the interface terminals then yes you can but if you are splicing the wires from the motor to use a longer wire for mounting the controls then that would void the warranty on the motor.
Reply
1 to 2 hrs
Screwdriver, Pliers
1 1
Parts needed:
4 conductor 22 gauge cable of required length
1/2 inch cable gland
Remove user interface from motor.
Disconnect existing cable from connectors
Remove plug from motor housing and replace with cable gland
Feed new cable through gland and tighten
Connect new cable to connectors
Plug connectors into user interface and motor
Mount user interface where desired
