?     Asked on 6/8/2006by Guest

How much sand is needed for this filter?
 Reply

A  Answered on 6/8/2006 by InyoPools Product Specialist Patrick P.

150 lbs.
 Reply


?     Asked on 7/4/2006by Guest

What is the voltage on this unit? How long is the manufactures warranty? If the system requires repairs during warranty, what do I do?
 Reply

A  Answered on 7/4/2006 by InyoPools Product Specialist Patrick P.

This pump runs on 115V power. This unit comes with a 1 year manufacturer's warranty. If the pump needed repair, you would call Hayward directly and they would put you in touch with a warranty service station in your area.
 Reply


?     Asked on 9/24/2006by Guest

What is the flow rating for this filter? Are the connections 1 1/2" or 2" and is it a 2 speed pump?
 Reply

A  Answered on 9/24/2006 by InyoPools Product Specialist Patrick P.

The designed flow rating for the S180T filter is 35 GPM the pump and filter both have 1.5" connections and this is a single speed pump 
 Reply


?     Asked on 1/27/2012by Guest

When should I change the sand in my filter?
 Reply

A  Answered on 1/27/2012 by InyoPools Product Specialist Patrick P.

You should change the sand in your filter every 5-7 years. You can generally tell that it is time if your pool water is not as clear as it normally is or when you notice the interval between backwashes is shorter. You can use > this guide to walk you through it.
 Reply


?     Asked on 3/1/2012by Guest

How often do I have to replace the sand in my filter? What is normal operating pressure?
 Reply

A  Answered on 3/1/2012 by InyoPools Product Specialist Patrick P.

On a "fresh start-up" a filter would operate anywhere between 10-20 psi. As a general rule of thumb you only want to backwash when the pressure increases 8-10 psi. You want to make certain that the pump is being turned off whenever you move the handle on the valve. Once backwashing is complete (3-5 minutes), you can switch to the rinse option to re-settle the sand bed. Sand will typically last 5-7 years. Premature backwashing will wear down the size of the sand which will cause difficulties such as cloudy water and higher operating pressures.
 Reply


?     Asked on 5/2/2013by Guest

I have a 24' round 52" above ground swimming pool, will the Hayward S180T93SFT be adequate?
 Reply

A  Answered on 5/2/2013 by InyoPools Product Specialist Patrick P.

Yes, the S180T93SFT would be sufficient for your size swimming pool.
 Reply


?     Asked on 7/17/2015by glenn

i have a 16' x 32' oval, 16,000 gal. above pool. is this Hayward  Pump & Filter S180T Filter W/ 1.5 HP Matrix Pump & Timer big enough for my pool?
 Reply

A  Answered on 7/17/2015 by InyoPools Product Specialist Hector F.

Yes both the filtration and circulation rating on that system is sufficient for your pool.
 Reply


?     Asked on 5/11/2016by Inyo Visitor

does filter run all the time
 Reply

A  Answered on 5/11/2016 by InyoPools Product Specialist Hector F.

No, it depends on the season, climate and needed hours to turnover the water, On average pool pumps run between 6-8 hours a day between spring to fall.
 Reply


?     Asked on 6/15/2017by Robert Callahan

what pump do you recommend for a 18x33x52?
 Reply

A  Answered on 6/15/2017 by InyoPools Product Specialist Patrick P.

If you are looking for a pump and filter combo for an 18' x 33' above ground pool then this is the system I would suggest. If you just need a pump then I would suggest the Hayward Matrix 1.5 HP Pump
 Reply


?     Asked on 6/30/2017by Inyo Visitor

What kind of hoses would I use with this filter?
 Reply

A  Answered on 6/30/2017 by InyoPools Product Specialist Lennox H.

Hi. The hoses, adapters, and clamps are included with this package. 
 Reply